Remote control of kx3 with n1mm logger
![remote control of kx3 with n1mm logger remote control of kx3 with n1mm logger](http://n1mmwp.hamdocs.com/wp-content/uploads/2019/04/Netgear-routing-example.png)
set menu 6-1 RTTY polarity to "reversed" on
REMOTE CONTROL OF KX3 WITH N1MM LOGGER SERIAL
switch serial port function to RS232C (CAT), menu. for RTTY AFSK or any other digital modes use DATA mode and rear panel switch must be in AFSK position
REMOTE CONTROL OF KX3 WITH N1MM LOGGER PRO
I have now got the SunSDR2 PRO radio too and I occasionally want to also use it with N1MM Plus as a contest logging program ie. for FSK RTTY use radio DATA LSB mode and rear panel switch must be in FSK position. Until now, I have been successfully using N1MM Logger Plus on all modes (CW, RTTY, & PSK) with my Elecraft K3 & a MicroHam 11 interface. do not use rear PTT (PTT2) in CW/USB/LSB use PKT/DATA mode for AFSK digital modes do not use PTT in CW mode (except for Orion) has not connected ACC jack properly, look at set both front and rear panel PTT (PTT1+2) for digital modes short together HSEND and VSEND (pin 6+3) on ACC2 for proper VHF/UHF PTT keying address must be different to CI-V Address! can be ON if logger is not confused by automated dataĬI-V USB to Remote Transceive address = default remote address of the radio microphone configuration in keyer must be set to EL (MK, MKII) or preamplifier bypassed (MK2R, MK2R+) for stock microphoneįor simultaneous USB and CI-V (REMOTE jack) CAT control keeping both band data for microHAM products, and spectrum screen replication in logger use these settings:ĬI-V Address = default CI-V address of the radio whenever possible, use USB D/LSB D instead USB/LSB for AFSK
![remote control of kx3 with n1mm logger remote control of kx3 with n1mm logger](http://n1mmwp.hamdocs.com/wp-content/uploads/2019/04/BandMap-RadioControlButton-RightClickEditDialog.png)
set CI-V baud rate to some particular baud rate, not Auto
![remote control of kx3 with n1mm logger remote control of kx3 with n1mm logger](https://i0.wp.com/www.hcra.org/wp-content/uploads/2018/09/HH-1.jpg)
Due to its construction it is possible to plug it in upside-down. make sure DIN13 ACC plug is correctly inserted to the radio. if you have P3, CAT connection flow is microHAM interface - P3 (PC jack) - K3.īaud rate set to 38400 in all Router, P3 and K3 Use E980297 adapter supplied by Elecraft for K3S use DATA A mode for all audio keying based (AFSK) digital modes if constant level audio output is low, add amplifier between interface and radio. use separate 12V power supply if radio does not provides auxiliary 12V output.ĭo not use same 12V power supply for interface as for transceiver. turn OFF internal CW keyer in the radio Most important transceiver settings and notes related to proper operation with our products.